INSTALL UNIT INTO WALL SLEEVE
1. Carefully remove shipping tape from the front
panel and vent door. See Fig° 8o
2. Remove shipping screw from the vent door, if
present. See Fig. 9.
3. Remove front panel. See Fig. 10.
4. Lift unit level and slide unit into wall sleeve
until foam seal rests firmly against front of wall
sleeve.
5. Secure with four screws (supplied) through the
unit flange holes. See Fig. 11.
6. Reinstall front panel. See Fig. 12.
PERSONAL INJURY HAZARD
Failure to follow this warning could result in personal
injury or death.
Chassis weighs up to 150 pounds (68.0 kg). Seek help
when lifting unit.
Lift unit by holding unit basepan.
L
..............., @_
Pull out at the bottom to release it from the tabs
(1). Then lift up (2).
Fig. 10 - Removing Front Panel
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Failure to remove shipping tape and screw will prevent
fresh air vent door from opening and may result in damage
to vent door cable
J
_f
J
/
j_
zJ
Fig. 11 - Securing Unit
Fig. 8 - Shipping Tape Location
. • .... J-J
Remove shipping
if present
Fig. 9 - Shipping Screw Location
Place tabs over top rail (1). Push Inward at
bottom until panel snaps into place (2).
Fig. 12 - Replacing Front Panel
To Next Page
Loading...
Need help?
General
