Ducted Type Split Air-Conditioner Units(Inverter Series)
2
(3) Make sure that the wiring is done by the qualified technicians according to
the relevant regulations.
(4) In fixed circuit, there must be electricity leakage protection switch of
enough power capacity and air switch with enough space.
(5) An all-pole disconnection device which has at least 3mm separation
distance in all pole and a residual current device(RCD)with the rating of
above 10mA shall be incorporated in the fixed wiring according to the
national rule.
(6) The appliance shall be installed in accordance with national wiring
regulations.
(7) The temperature of refrigerant circuit will be high, please keep the
interconnection cable away from the copper tube.
2 Installation of Indoor Unit
2.1 Selection Proper Installation Location
(1) Avoid the direct sunshine.
(2) Make sure the suspension bracket is strong enough to withstand the unit’s
weight.
(3) Select a place for easily connection of the drain hose.
(4) The inlet and outlet ports should not be obstructed so that the indoor air
circulates well.
(5) Make sure the convenient connect of the connection pipes.
(6) Selection a location that is far away from the combustible or explosive
material and gas.
(7) Selection a location that is far away from the cankerous material, fog,
dusk or moist.
2.2 Outline Dimension and Installation Spots
Equip with an inspection hatch after lifting the unit. For the convenience of
maintenance, the service port should be on one side of the electric box and below
unit’s lower level.
To Next Page
Loading...
Need help?
General
