GREE DC INVERTER HEAT PUMP CONDENSING UNIT
69
4.5 Removal of Major Components
4.5.1 Removal of ODU Major Components
Through compression, the low pressure refrigerant occupies a less space.
As its pressure and temperature both rise, it becomes high pressure and
high temperature refrigerant. It is the power drive of the system.
It is used to change directions, the flow of refrigerant in cooling/heating.
The power drive of the fan. It enables the fan to run so as to provide
smooth currents of air for forced convection and heat exchange of
condenser and evaporator.
It is used to provide smooth currents of air for forced convection and heat
exchange of condenser and evaporator.
Installed at the suction side of compressor, it can separate the liquefied
refrigerant from the gaseous refrigerant to make sure that only gaseous
refrigerant will be sucked into the compressor. If liquefied refrigerant gets
inside the compressor, ineffective compressor or slugging phenomenon
will occur.
To Next Page
Loading...
Need help?
General