22
Floor Ceiling Type Fan
Coil Unit Service Manual
2 Selection of installation location
(1) Such a place where cool air can be distributed throughout room.
(2) Such a place where condensation water is easily drained out
(3) Such a place that can handle the weight of the unit.
(4) Such a place which has easy access for maintenance.
(5) Such a place where is permitting easy connection with the chilling water pipe.
(6) Such a place where is 1m or more away from other electric appliances such as television, audio device,
etc.
(7) Avoid a location where there is heat source, high humidity or inammable gas.
(8) Be sure that the installation conforms to the installation dimension diagram.
(9) The space around the unit is adequate for ventilation(Refer to Fig.2)
(10) The height of the installed location should be 2.3m or more from the oor.
INSTALLATION
PAPER PLANK
150cm or more
60cm or more
100cm or more
30cm or more
60cm or more
Fig.1 Fig.2
3 There are 2 styles of installation
(1) Ceiling Type
(2) Floor Type
Each type is similar to the other as follows;
1) Determine the mounting position on ceiling or wall.
2) Remove the return grill, the side panel, and suspender from the unit as per procedure below.
Press the xing knob of the return grilles, the grilles will be opened wider and then pull it out from the unit.
(3) Remove the side panel xing screw and pull to the front direction(arrow direction) to remove.(Refer to
Fig.3)
(4) Loosen two hanger bracket setting bolts(M8) on each side for less than 10mm. Remove two hanger
bracket xing bolts(M6) on the rear side. Detach the hanger bracker by pulling backward (Refer to Fig.5)
Fig.3
(5) set the suspension bolt.(Use W3/8 or M10 size suspension bolts)
Adjust the distance from the unit to the ceiling slab beforehand (Refer to Fig.4)
To Next Page
Loading...
Need help?
General
