22
Remove Collected Water: Continuous
Drainage Lower Hole Option
During cooling or drying operations, water will condense and drain into the chassis. When the chassis is
full with water, a buzzer will sound and “H8” will display on the unit.
• Move the unit to a suitable place, keep the unit horizontal.
• Take the
Drainage Pipe from the Pipe Clip, and pull out the Rubber Plug in the Drainage Pipe to
discharge the water.
• After discharging the water, replace the
Rubber Plug in the Drainage Pipe and then place the
Drainage Pipe onto the Pipe Clip.
• After the water is removed, and the compressor has been stopped for 3 minutes, the unit will resume
operation.
CLEANING AND MAINTENANCE
NOTICE:
This picture is for reference only. Please refer to the actual product for the appearance.
To Next Page
Loading...
Need help?
General
