7
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
The remote control signal has a range of
up to 20 feet.
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
Make sure batteries are fresh and installed
correctly as indicated on the remote control.
Use the mode at or
for cooling. Use the
pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the
room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
Cool Low, Med, High Auto Fan
Speed Temperature Increase ▲
/Decrease ▼
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool setting, it may take approximately 3 minutes
for the compressor to start and cooling to begin.
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. If the
Set to fan speed for the fan speed to auto-
matically set to the speed needed to provide opti-
mum comfort settings with the set temperature.
If the room needs more cooling, the fan speed
will automatically increase. If the room needs less
cooling, the fan speed will automatically decrease.
feature was set, it will countdown according to the
memorized time. You may need to set a new time if
desired.
Power Outage Recovery Feature
Auto
Use the Mode at or fan
speed to provide air circulation and filtering
without cooling. Since fan only settings do not
provide cooling, a temperature can not be
entered. The room temperature will appear
in the display
The fan will cycle on and off with the compressor. This
results in wider variations of room temperature and
humidity. Normally used when the room is unoccupied
NOTE: The fan may continue to run for a short time after
the compressor cycles off.
Fan Only Low, Med High
Set
.
When the air conditioner is off, it
can be set to automatically come on in 1 to 24
hours at its previous mode and fan settings.
When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
Press the pad on the unit or
the pad on the remote control. Each touch
of the pads on the
unit or the pads on
the remote control will set the timer in
1-hour intervals. The light will turn on
while setting.
Increase ▲ / Decrease ▼
Increase
+ / Decrease –
Set
To review the remaining time on the
timer, press the pad on the
unit or the pad on the remote control. Use
the pads on the unit
or the pads on the
remote control to set a new time if desired.
press the pad
until the light on the pad goes off.
During preview of timer or timer setting, press
button on the panel or Delay 1-24hr Delaybutton
on the remote controller to cancel the timer setting.
Delay
1–24hr Delay 1–24hr
Increase ▲ / Decrease ▼
Increase + / Decrease –
To cancel the timer, Delay 1–24hr
Delay 1–24hr
Cooling Descriptions
For Normal Cooling—
Select the mode and
or fan with a middle set temperature.
Select the mode
and fan with a lower set temperature.
Select the
mode and fan with a middle set
temperature.
Cool
High Med
For Maximum Cooling— Cool
High
For Quieter & Nighttime Cooling—
Cool Low
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
NOTE: Auto Fan Speed cannot be used when in the
Fan Only Mode.
To Next Page
Loading...
Need help?
General
