4040
GB
275-531-161204
Model RT250/5 RT301/5
Operating voltage V~, Hz 230~, 50 230~, 50
Watt W 250 300
No-load speed min
-1
10.000 10.000
Cutting width cm 24 25
Line diameter mm 1,2 1,2
Line length m 2 x 3 2 x 3
Weight kg 1,5 1,5
Safety class II
Guaranteed sound power level: 96 db(A)
Sound Pressure Level: 71,7 db(A)
Vibration: 2,8 m/s
2
Technical Data
Fault Finding
Problem Possible cause Fault correction
Spool soiled
Clean spool (see chap.
Maintenance and cleaning)
Device vibrates
Spool defective
Replace spool (see chap. on
Maintenance and cleaning)
Mains voltage not applied
Check plug socket, cable, line
and plug, where appropriate,
have repaired through electrical
specialist
On/Off switch defective
Worn carbon brushes
Device does not start
Defective motor
Repair through customer service
Thread spool does not
have sufficient line
Adjust nylon line (see chap. on
operating the lawn trimmer)
Replace spool (see chap. on
Maintenance and cleaning)
Inferior cutting performance
Thread is not guided out of
spool or extends from the
spool on one side only
Remove spool and thread line
through the openings to outside,
mount spool again.
Noise and vibration values were determined according to the standards and stipulations men-
tioned in the declaration of conformity.
Technical and optical changes can be carried out in the course of further development without
notice. All dimensions, references and information of this instruction manual are therefore
without guarantee. Legal claims, which are made on the basis of the instruction manual, can-
not thus be considered as valid.
To Next Page
Loading...
Need help?
General
