A simple turn of the thermostat controls the Groen
TDB and TDBC kettle.
Initial Start-Up
IMPORTANT:
BE SURE ALL OPERATORS READ, UNDERSTAND AND FOLLOW THE OPERATING
INSTRUCTIONS, CAUTIONS, AND SAFETY INSTRUCTIONS CONTAINED IN THIS MANUAL.
Now that the kettle has been installed, you
should test it to ensure that the unit is operating
correctly.
1. Remove all literature and packing
materials from inside and outside of the
unit.
2. Turn on the electrical service to the unit.
3. Pour 1-2 quarts of water into the kettle.
4. Following “To Start Kettle” instructions in
the “Operation” section of this manual,
begin heating the water at the highest
thermostat setting. The heating indicator
light should come on immediately, and
heating should continue until the water
boils.
5. To shut down the unit, turn the thermostat
dial to “OFF”.
WARNING
AVOID ALL DIRECT CONTACT WITH HOT
SURFACES. DIRECT SKIN CONTACT
COULD RESULT IN SEVERE BURNS.
AVOID ALL DIRECT CONTACT WITH HOT
FOOD OR WATER IN THE KETTLE.
DIRECT CONTACT COULD RESULT IN
SEVERE BURNS.
If the unit functions as described above, it is
ready for use. If the unit does not function as
intended, first recheck power supply connections
and, if necessary, contact your local Groen
Certified Service Agency.
To Next Page
Loading...
Need help?
General
