H.E. Anderson Ratio:Feeder J Plus Series User Manual

Warnings and Cautions
WARNING! Always appropriate
protective equipment (goggles,
protective clothing, respirator
etc.) when working with
chemicals and observe all relevant
guidelines and laws.
Set up your controller before
starting up your system. Refer
to the J Plus Controller
manual. Controllers are often
shipped with proper settings already
entered.
Store protective clothing and
accessories in a location away
from the injector so that they
may be donned before
approaching the equipment.
Do not store chemicals in
tanks where the level will be
more than just a few feet
above the discharge point of
the pumpers. If you have very large solution
storage tanks you should use them to fill
smaller “day tanks”. This will eliminate the
chance of large quantities of chemicals
draining into your watering system.
WARNING! Water hammer
destroys diaphragms. Damage
caused by water hammer is
not covered under warranty.
WARNING! Never allow the
unit to freeze! Damage due to
freezing is not covered by the
warranty.
Never transfer the suction line
of a feeder pumping a strong
acid or alkali to a container of
water. This can generate
dangerous heat which may destroy your
pumper and plumbing.
IMPORTANT! The waste line
must exit to atmospheric
pressure and must not be
elevated or restricted in any
way.
WARNING! Connecting the
flow sensor incorrectly can
damage the flow sensor
electronics.
3

H.E. Anderson Ratio:Feeder J Plus Series Specifications

General

Brand	H.E. Anderson
Model	Ratio:Feeder J Plus Series
Category	Laboratory Equipment
Language	English