Self-contained accessories
3. Accessories for installation
Name of
Parts
No. A B
C D E F
Non-adhesive
Tape
Adhesive
tape
Connecting
Hose
Gypsum
powder
Drain hoseHeat insulation
material
4. Choose the installation place
Install the indoor unit where the weight of the unit can be supported.
Install the indoor unit where the heat source and steam source are not close and the unit inlet
and outlet are not blocked.
Install the indoor unit where the drainage is easy and the outdoor unit can be easily connected.
Install the indoor unit where its cold air and hot air can be easily sent to all the corners of the
room.
Install the indoor unit where the power socket is near and there is sufficient space around the
indoor unit.
Install the indoor unit where there is no T.V set, radio set, and wireless appliance underneath,
and the sunlight lamp is over one meter away.
If the remote controller is installed on the wall, the indoor unit shall be ensured to receive the
signal while the sunlight lamp is on.
2. Preparation for installation
Installation tools
7 Pipe Cutter
14 Refrigeration Oil
6 Spanner
13 Scraper or File
5 Shifting Spanner
12 Measuring Tape
4 Inner Hexagon Spanner
11 Leakage Checker or Soap Liquid
3 60mm Drill
10 Clippers
2 Steel Saw
9 Knives
1 Screw Driver (flat head, wabbler, triangle)
8 Pipe Expander
>_]]VbTZR\ <Zb >_^UZdZ_^Vb
4.7 Duct type AD***ERA
-64-
To Next Page
Loading...
Need help?
General
