When using this appliance, always exercise basic
safety precautions, including the following:
o
●
This dehumidifier must be properly
‘Q~:$
. installed and located in accordance
. .
.
with the Installation Instructions
before it is used.
●
Use this appliance only for its intended purpose
as described in this Use and Care Guide.
●
This dehumidifier must be properly grounded
before it is used. See
grounding instructions in
the Installation section.
●
Never operate this appliance in an area that is
likely to accumulate standing water,
If this
condition develops, for your safety disconnect the
power supply before stepping into the water,
●
Never unplug your dehumidifier by
P“lling
on
the
power
cord.
Always
gfip
plug firmly and pull straight out from the
receptacle.
●
Repair or replace immediately all electric
service cords that have become frayed or
otherwise damaged.
Do not use a cord that
shows cracks or abrasion damage along its
length or at either the plug or connector end.
SAVE THESE
INSTRUCTIONS
How it works
Moist, humid air is drawn over a cold, refrigerated
Dehumidifying Coil
Condenser
dehumidifying coil. Moisture in the air condenses on
this coil and then drains into a bucket (or through a
hose into a drain). Dry, clean air is then drawn over the
condenser where it is actually heated several degrees
and discharged out the front
grille
into the room. It is
normal
for
the surrounding air to become slightly
warmer as the dehumidifier operates. This warming
effect further reduces the relative humidity of the
surrounding air.
When locating the dehumidifier, be sure to place it
where there is no restriction to the air flow either into
the coil at the rear or from the front grille. Good air
circulation through the appliance is essential to
efficient operation.
\
Humid “
Air In
*
Drain —
r
Bucket
~
r
—
—
———
o-
b
—-
—
Air
/
:::ulating
%
\
Dry
%
Air
out
%
Sealed
‘
Refrigeration
Unit
Appearance may vary
(c(]ntinued
next page)
3
To Next Page
Loading...
Need help?
General
