SERVICE MANUAL
Model: CFE629CW
11
Issue 2009-12-23
Rev. Ref0912S021V0
3-2-2 Dismantle and install the upper decoration strip and cables
PART-2 Before change
After change
(1) Remove the decoration covers from the door and retain.
(2) Remove the upper decoration strip from the door. Insert a “-”screwdriver into the decoration strip at
the position shown by the arrow and lightly pull the screwdriver handle in the arrow direction while
pulling the decoration strip upward with another hand. In this way the decoration strip will detach
away from the door. The operation methods on the right side and the left side are the same.
(3) Disconnect the connectors and pull out the cables in the door conduit and the cables in the upper
hinge conduit respectively.
(4) Loosen the screws affixed to the upper hinge to remove the hinge. At the same time, the
refrigerating compartment door can be lifted up and separated from the middle hinge.
(5) Pull the axis from the upper hinge. Then, insert it from the other end of the upper hinge. Insert the
upper hinge by placing the axis into the door axis hole after turning 180 degrees.
(6) Remove the stop block on the bottom of the door and then reatacht on the other side of the door
after turning 180 degrees.
(7) Turn the middle hinge by 180 degrees and then fit it on the other side of the cabinet.
(8) Hang the door on the middle hinge and secure the hinge’s screws. Connect the two connectors
together. Tuck the cables for the door into the conduit on the other side of the door and the cables
for the cabinet into the upper hinge conduit.
(9) Tuck the connected connectors into the conduit on the upper decoration strip and joint the upper
decoration strip on the door.
(10) Turn the decoration piece by 180 degrees and insert it between the door and the upper decoration
Upper decoration strip
Decoration cover
Upper hinge axis
Upper hinge
Cables in cabinet
Connector
Cables for the doors
Connector
Cables in cabinet
To Next Page
Need help?
General
Weight and Dimensions
