2
Operation
Unit start / stop
Note:
In DRY mode,when room temperature becomes lower than temp.setting
+2 C, unit will run intermittently at LOW speed regardless of FAN setting.
In HEAT mode,warm air will blow out after a short periodof the time
When FAN is set to AUTO, the air conditioner automatically adjusts
next time,just press ON/OFF button and unit will run in previous status.
Remote controller can memorize each operation status. When starting it
Cooling only unit do not have displays and functions related with heating
Press ON/OFF button, unit starts or stops.
According to the automatic
choice system in temperature
in indoors cold or make the
automatically adjusts
1.
2.In FAN operation mode
Auto Operation
Cool Operation
Heat Operation
Dry Operation
Fan Operation
When FAN is set to AUTO,
the air conditioner
the fan speed according
to room temperature.
the unit will not operate
in COOL mode but only
in FAN mode ,AUTO is not available in FAN mode.And temp.setting is disabled.
due to cold-draft prevention function.
the fan speed according to room temperature.
Note:
Air Flow Direction Adjustm
Select temp.setting
hot movement.
Health airflow Operation
The setting of health airflow function
1).Press the button of health airflow, appears
on the display. Avoid the strong airflow blows
2).Press the button of health airflow again,
appears on the display. Avoid the strong
Note:
1 .After setting the health airflow function, the position of inlet and outlet grills is fixed.
2.In heating, it is better to select the mode.
3.In cooling, it is better to select the mode.
4.In cooling and dry, using the air conditioner for a long time under the high air humidity,
a phenomenon falling drips of water occurs at the outlet grille .
5.Select the appropriate fan direction according to the actual conditions.
direct to the body.
strong airflow blows direct to the body.
3.The cancel of the health airflow function
Press the button of health airflow again, both the inlet and outlet grills of the
air conditioner are opened, and the unit goes on working under the condition
before the setting of health airflow function.
After stopping, the outlet grille will close automatically.
Notice: Cannot pull direct the outlet grille by hand. Otherwise,the grille will run
incorrectly. If the grille is not run correctly,stop for a minute and then start,
adjusting by remote controller.
0
Display Board
Remote
Controller
Note
COOL
DRY
HEAT
FAN
nothing
In DRY mode, when room temperature becomes
lower than temp.setting+2
o
C,unit will run intermittently
at LOW speed regardless of FAN setting.
Under the mode of auto operation, air conditioner will
automatically select Cool or Heat operation according
to room temperature.
air conditioner
automatically adjusts the fan speed
temperature.
When FAN is set to AUTO, the
according to room
In FAN operation mode, the unit will not operate in
COOL or HEAT mode but only in FAN mode ,AUTO is
not available in FAN mode.And temp.setting is disabled.
In FAN mode,SLEEP operation is not available.
Operation
Mode
AUTO
AUTO LO MED HI
Vertical flap
Pos.1
Pos.2
Pos.3
Pos.4
Pos.5
Pos.6
(Auto
swing)
Horizontal louvers
Pos.1
Pos.2
Pos.3
Pos.4
Pos.5
Pos.6
Pos.7
Pos.8
(This function is unavailable
on some models.)
FRESH
FRESH
To Next Page
Loading...
Need help?
General
