HSU12HG(DB)-SM
Introduction
Operation
Sleep Operation
If the wind speed is high or middle before setting for the
sleep, set for lowing the wind speed after sleeping.
If it is low wind, no change.
5.Set the wind speed change when sleeping
Use of SLEEP function
Operation Mode
1. In COOL,DRY mode
SLEEP operation starts SLEEP operation stops
SLEEP
operation starts
SLEEP
operation stops
Approx.6hrs
1 hr
1 hr
1 hr
3 hrs
3 hrs
Rises 1
O
C
Rises 1
O
C
Rises 1
O
C
Temp.setting
Temp.setting
Unit stop
Unit stop
In COOL, DRY mode
In HEAT mode
Decreases 2
O
C
Decreases 2
O
C
1 hr
2.
3.
In HEAT mode
In AUTO mode
4. In FAN mode
It has no SLEEP function.
Note
When TIMER function is set, the sleeping function can’t be
set up .After the sleeping function is set u
p
,
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of
timing-on.
POWER/SOFT Operation
HEALTHY Operation
Healthy Negative ions
Before going to bed,you can simply press the SLEEP
button and unit will operate in SLEEP mode and bring
you a sound sleep.
After the unit starts,set the operation status,then press
SLEEP button before which the clock must be adjudted
and time being set.
1 hours after SLEEP mode starts,temp.will become
higher than temp.setting.After another 1 hours,temp.rises
by 1 futher.The unit will run for further
6 hours then stops
Temp. is higher than temp.setting so that room temperature
won’t be too low for your sleep.
1 hours after SLEEP mode starts,temp will become 2
lower than temp.setting.After another 1 hours,temp
decrease by 2
rises
by 1 futher.The unit will run for further 3 hours then
stops.Temp.is lower than temp. setting so that room
temperature won’t be
too high for your sleep.
The unit operaters in corresponding sleep mode
adapted to the automatically selected operation
mode.
The anion generator in the airconditioner can generate a lot
of anion ef
fectively balance the quantity of position and anion
in the air and also
to kill bacteria and speed up the dust
the room and finally clean the air in the room.
O
C
O
C futher.After more another 3 hours,temp.
O
C
(1)
POWER Operation
(2)
SOFT Operation
Press POWER/SOFT button again ,POWER or SOFT
disappear
s.
To cancel POWER or SOFT operation
Note
When you need rapid heating or cooling, you can use this
function.
In COOL mode, fan speed automatically takes
high speed of AUTO fan mode. In HEAT mode, fan speed
automatically takes medial speed of AUTO fan mode.
You can use this function when silence is needed for rest or reading.
In SOFT operation mode, fan speed automatically takes low speed
of AUTO fan mode.
During POWER operation, in rapid HEAT or COOL
mode , the room will show inhomogeneous temperature
distribution. Long period SOFT operation will cause
effect of not too cool or not too warm.
1
O
C
O
C
if user resets
sediment in
UV light emitted by the UV light device of the indoor unit
catalytically
activates the nano TiO
2
on the multi-lights
touching intermediary,
and the degerming effect is highly
Note: when the function is running, don't open the inlet grille.
About UV light degerming function
efficient and lasting.
To Next Page
Loading...
Need help?
General
