Initial Setup
Once you have plugged the unit into an electrical outlet,
letthe unit run for at least30 minutes to acclimate itself before
making any adjustments. During this lime the Red Wine light may stay on.
Temperature Adjustments: seeFig.#1
The wine cooler is preset from the factory to automatically
accommodate temperature requirements for red or white wines.
If you store mostly white wines, pressthe 'White Wine" button and the
wine cooler will maintain an average temperature between
45" to 50" F.Pushing the "Red Wine" buttonwill yield an
average temperature between 55" to 60" F.
The wine cooler can be set to any temperature you desire to
accommodate your wine storage requirements. To setthe temperature,
press both the "White Wine" and "Red Wine" buttons simultaneously
and hold for approximately 3 seconds. Now you are in temperature set
mode. Decrease the temperature by pushing the "White Wine" button
and increase the temperature by pressing the nRedWine" button.
Pressingthe appropriate button 3 times will adjustthe temperature 3
degrees, press4 timesequals 4 degrees, 5 times equals 5 degrees, and
so on. Once you have selectedthe temperature you desire, pushthe
'Light/Set" button. Now the wine cooler is programmed and the LED
readout will return to current internal temperature reading.
fig.# I
I I
WSh Rod Ligl_
oF
7
To Next Page
Loading...
Need help?
General
