DISMANTLE THE TRANSPORTATION BOLTS
The transportation bolts are designed for clamping anti-vibration components inside
of the washing machine during the transportation process.
Remove the back cover.1.
Remove the three bolts on the rear side and take out the synthetic 2.
stabilisers from within the machine.
Replace the back cover.3.
Fill the holes left by the bolts with blanking plugs.4.
Note:
2.When you replace the back cover,the convexity must face to
outside, and you have to insert the back cover from the two gaps
as shown in fig.3.
3.Keep the transportation bolts and synthetic stabilisers
in a safe place for later use.
INSTALLATION
ADJUSTING THE WASHING MACHINE
There are adjustable feet under the bottom of the washing machine. Before use, they should be
adjusted so that the machine is level. This will minimise vibrations and thus noise during use. It will
also reduce wear and tear. We recommend using a spirit level to level the appliance.The floor should be
as stable and flat as possible.
ADJUSTING THE BOTTOM COVER
When open the carton package, you will find a metalline board
which is laid on the top of the washing machine as shown fig.1,
the board used for reducing noise and rat proof by install it under
the cabinet when setting as shown in fig.2.
1.Before removing the back panel for any reason. Isolate the
electric power from the washing machine by switching of the
supply and removing the plug.
To Next Page
Loading...
Need help?
General
