of a problem please check all shown possibilities and follow below instructions before you
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶
improper repairs can cause considerable consequential damages.
▶ A damaged power cable should only be replaced by the manufacturer, its service
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
The remaining wash cycle time will be 1 hour and 25 minutes.
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 minutes.
AUTO
Automatic load detection is working; only in some programmes.
End
Door is closed because of high water level, high water temperature or spinning cycle.
bEEP OFF
The buzzer is deactivated.
bEEP ON
The buzzer is activated.
9.2 Troubleshooting with display code
Problem Cause Solution
CLR FLTR
• Drainage error, water is not fully drained
within 6 minutes.
•
•
Check drain hose installation.
E2
• Lock error. • Shut the door properly.
E4
•
• Drain hose is self-syphoning.
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
E8
• Water protective level error. • Contact the After sales service.
The function keys is closed.The programme changing is invalid.
9-Troubleshooting
EN
22
Water level not reached after 12 minutes.
E5
▶ For the safety of the end-user ,self-repair or non-professional repair is not
recommended. Please contact an after sales service.
To Next Page
Loading...
Need help?
General