To Next Page

To Previous Page

The front panel menu references

The following table summarizes the front panel keys and menu structure.

Keys

Application

Configure DC voltage measurement, including DCV ratio measurement:

Range: Automatically adjust range (default), 100 mV, 1 V, 10 V, 100 V or 1000V

Aperture PLC: 0.02, 0.2, 1, 10, 100. Default value: 10

Auto Zero: Off or On (default)

Input Z: 10 M Ω (default) or Auto Ω (> 1 G)

DCV ratio: Off (default) or On

Configure DC current measurement:

Terminals: 3 A or 10 A

Range: Auto, 100 µA, 1 mA, 10 mA, 100 mA, 1 A, 3 A or 10 A (Terminals set to 10 A).

Aperture PLC: 0.02, 0.2, 1, 10, 100. Default value: 10

Auto Zero: Off or On (default)

Configure AC voltage measurement:

Range: Automatically adjust range (default), 100 mV, 1 V, 10 V, 100 V or 750 V

AC Filter: >3 Hz, >20 Hz, >200 Hz

Configure AC current measurement:

Terminals: 3 A or 10 A

Range: Auto, 100 µA, 1 mA, 10 mA, 100 mA, 1 A, 3 A or 10 A(terminal set to 10 A)

AC Filter: >3 Hz, >20 Hz, >200 Hz

Configure 2-wire resistance measurement:

Range: 100 Ω, 1 kΩ, 10 kΩ, 100 kΩ, 1 MΩ, 10 MΩ or 100 MΩ

Note: The approximate current sourced for each range (for example, ~1mA) is shown on

each range softkey.

Hantek HDM3000 User Manual

Other manuals for Hantek HDM3000