20
First use of the multimeter
When using the multimeter for the first time, refer to the steps below to start the
multimeter.
1. Connect the AC power supply.
1) Adjust the power supply voltage selector on the rear panel according to
your power supply voltage.
2) Connect the multimeter to the AC power supply using the power cord.
2. Start the multimeter.
Press the power button on the front panel to start the instrument.
3. Start-up process
Normal startup: Display the user interface.
4. If the instrument does not start normally, please follow the following steps to check.
1. Check whether the power cord is in good connection.
2. If the instrument is still not started after checking without error, please check whether
the power fuse has been blown. If necessary, please replace the fuse.
3.
If the instrumentis still not started after the above check, please contact
Qingdao Hantek Electronic Co., Ltd.
To Next Page
Loading...
Need help?
General
