Name: Harman Kardon AVR 10
Brand: Harman Kardon
Rating: 5 (1 reviews)

To Next Page

harman/kardon Service Bulletin

Service bulletin # 9706 November 1997 Warranty labor rate: MINOR repair

To: All harman/kardon Service Centers

Models: AVR 10/20/25/3250; AVI 100/150/200

Subject: Remote Control has stopped working

In the event you receive a complaint about a remote control that has stopped working, perform

the following tests:

1) Remove the batteries and confirm they are not weak or defective (battery voltage should be 1.4 volts

or more). Replace batteries if necessary; both batteries

in remote control should be replaced.

2) Point the remote towards the corresponding receiver/amplifier and confirm the remote control

functions operate as intended.

3) If Remote Control still doesn’t work:

Remove batteries, and with an alligator clip lead or other jumper wire, short the positive and negative

tabs inside the control together. (See drawing) This short will drain any remaining charge from

the capacitors in the remote control and re-set the microprocessor.

4) Re-insert batteries and test the functions as per item (2) above.

NOTE: This procedure may also work for other h/k model remote controls not listed above.

harman/kardon Incorporated 250 Crossways Park Drive, Woodbury New York 11797 (516) 496-3400

Other manuals for Harman Kardon AVR 10

Questions and Answers:

Need help?

Do you have a question about the Harman Kardon AVR 10 and is the answer not in the manual?

Power

continuous average power stereo mode	35 Watts from 20Hz-20kHz @ <0.09% THD, both channels driven into 8 Ohms
continuous average power five channel surround mode front L&R channels	30 Watts from 20Hz-20kHz @ <0.3% THD, both channels driven into 8 Ohms
continuous average power five channel surround mode center channel	30 Watts at 1kHz @ <0.3% THD, driven into 8 Ohms

Amplifier Section