Harman® • Absolute43 Owner’s Manual_R2 • 2015 -___ • 03/154
3-90-777000c
1
Product Specic and Important Safety Information
A. Appliance Certication / Specications C. BTU & Efciency Specications
The Absolute43 is EPAcertied to comply with July1990
particulate emission standards.
B. Mobile Home Approval
This appliance is approved for mobile and manufactured
home installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
Thestructuralintegrityofthemobilehomeoor,ceiling,and
walls must be maintained. The appliance must be properly
grounded to the frame of the mobile home and use only listed
pelletvent,Class“PL”or“L”connectorpipe.
AHarman
®
OutsideAirKitmustbeinstalledinamobilehome
installation.
NOTE: This installation must conform with local codes.
Intheabsenceoflocalcodesyoumustcomplywiththe
ASTM E 1509-04, ULC-S627-00, (UM) 84-HUD
MODEL: Absolute43PelletStove
LABORATORY: OMNITestLaboratories,Inc
REPORT NO. 135-S-32-2
TYPE: PelletFueled/SupplementaryFor
ResidentialUse
STANDARD(s): ASTME1509-12,ULC-S627-00
ELECTRICAL
RATING:
115VAC,60Hz,Start4.0Amps,Run
3.0 Amps
GLASS
SPECIFICATION:
5mm mirrored ceramic glass
EPA Certication Number: 967-14
EPA Certied Emissions: 1.8 g/hr
*EPA Default Efciency: 78%
**Actual Tested Efciency: 69.3%
***EPA BTU Output: 33,900
****BTU Input 43,000
Vent Size: 3Inch
Hopper Capacity: 52 lbs
Fuel WoodPellet,50/50
Pellet/CornMixture
NOTE: Hearth & Home Technologies, manufacturer of
thisappliance,reservestherighttoalteritsproducts,their
specicationsand/orpricewithoutnotice.
*An efciency based on EPA historical data of 78%
**Actual tested efciency and data collected during EPA
emissions test
***A range of BTU outputs based on EPA default efciency
and the burn rates from the low and high EPA tests
****Based on the maximum feed rate per hour multiplied by
approximately 8600 BTU’s which is the average BTU’s from
a pound of pellets.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Overre
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved.
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualied
installer, service agency or your dealer.
Harman
®
is a registered trademark of Hearth & Home
Technologies.
THE STRUCTURAL INTEGRITY OF THE
MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
DO NOT INSTALL IN SLEEPING ROOM.
WARNING
WARNING
Risk of Fire! Hearth & Home Technologies disclaims any
responsibility for, and the warranty and agency listing will
be voided by the below actions.