27
Table of Contents
Introduction Before You Begin................................................................... 1
Installation Steps.................................................................... 1
1. Mounting OnCommand Control Center............................................... 2
Equipment Temperature Sensors............................................................ 2
Wireless Remote Control...................................................... 2
Base Station........................................................................... 3
Optional Valve Actuators....................................................... 3
2. Plumbing Plumbing Configuration.......................................................... 4
3. Electrical Grounding............................................................................... 5
Wiring Input Wiring............................................................................ 5
High Voltage Pool Equipment............................................. 6
Low Voltage Wiring................................................................ 8
4. Configuration Configuration Menu............................................................... 13
5. System Startup Before Startup........................................................................ 26
and Checkout Heater Checkout.................................................................... 26
Service Mode......................................................................... 27
6. Warranty OnCommand Limited Warranty........................................... 28
• The display will periodically indicate that the filter pump is on for heater cooldown and show the minutes
remaining.
• The pump will automatically turn off at the end of the 5 minute heater cooldown period.
For more detailed instructions on control and operation of the OnCommand system, refer to the Operation Manual.
Service Mode
Service mode disables all automatic control operation and is intended to be used when servicing the pool system.
To enter service mode, push the SERVICE button once on the main unit keypad. This will initially turn all outputs
off and then allow you to turn outputs on/off manually at the main display (only). In service mode, the buttons on
the optional spa side remote will turn outputs off, but will not turn any output on. Heater control outputs and solar
control outputs are prevented from turning on if the water temperature exceeds 104ºF (40ºC).
Pushing the SERVICE button again will enter a timed service mode. Service operation as described above will
continue for 3 hours, then automatically return to normal operation.
Push the SERVICE button once more to exit out of Service mode.
To Next Page
Loading...
Need help?
General
