www.heinner.com
18
The programme does not start.
Your Dishwasher is not plugged in.
Your Dishwasher is not switched on.
Switch your Dishwasher on by pressing the On/Off
button.
Water inlet tap is closed.
Turn on the water inlet tap.
Your Dishwasher door is open.
Close the Dishwasher door.
Water inlet hose and machine filters are clogged.
Check the water inlet hose and machine filters and
make sure they are not clogged.
Water remains inside the machine.
Water drain hose is clogged or twisted.
Check the drain hose, then either clean or untwist it.
The programme is not finished yet.
Wait until the programme is finished.
Machine stops during washing.
Shaking and hitting noises are heard during a
wash operation.
The spray arm is hitting the dishes in the lower
basket.
Move or remove items blocking the spray arm.
Partial food wastes remain on the dishes.
Dishes placed incorrectly, sprayed water not
reaching affected dishes.
Dishes leaning each another.
Place dishes as instructed in the section on loading
your dishwasher.
Not enough detergent used.
Use the correct amount of detergent, as instructed
in the programme table.
Wrong wash programme selected.
Use the information in the programme table to select
the most appropriate programme.
Spray arms clogged with food waste.
Clean the holes in the spray arms with thin objects.
Filters or water drain pump clogged or filter
misplaced.
Check the drain hose and filters are correctly
fitted.
To Next Page
Loading...
Need help?
General
