HELIX ULTIMATE P SIX DSP User Manual

19
en
Hardware conguration
Congure the HELIX P SIX DSP ULTIMATE as
follows
Caution: Carrying out the following steps will re-
quire special tools and technical knowledge. In or-
der to avoid connection mistakes and / or damage,
ask your dealer for assistance if you have any
questions and follow all instructions in this manual
(see page 17). It is recommended that this unit will
be installed by an authorized HELIX dealer.
1. Setting the input voltage range (“Voltage
Range”) of the analog signal inputs
ATTENTION: When using the analog in-
puts (lowlevel & highlevel) as signal in-
put, it is mandatory to adjust the “Voltage
Range” to the output voltage of the signal
source before the rst start up in order to
avoid damage to the amplier.
At rst, the “Voltage Range” of the analog in-
puts has to be set inside the device. Remove
the bottom plate by loosening the 10 Allen
screws. Now you have access to the jumpers
(see g. 1). Each jumper sets the value range
for the corresponding input channels (J1 –
channel A - D and J2 – channel E - F).
If you want to connect a conventional OEM or
aftermarket radio as signal source, the jumper
must be set to “Low Voltage Range” (Line 1 -
4 V / Highlevel 4 - 16 V). This range is preset by
default, see g. 2.
If you want to connect a factory-installed am
-
plier as signal source, we recommend to de-
termine its maximum output voltage previously
with a suitable measuring device or to contact
your authorized HELIX dealer. If you are not
sure, we recommend to set the jumper to “High
Voltage Range” (Line 2 - 8 V / Highlevel 8 -
32 V) to avoid possible damage to the device.
Therefore, both jumpers have to be reposi
-
tioned to the factory unused multi-pin connec-
tor, see g. 3.
J 1 J 2
Overview jumper plug-in positions:
Jumper 1 (J 1): Channel A - D
Jumper 2 (J 2): Channel E - F
For repositioning a jumper simply pull it up-
wards and plug it into the desired plug posi-
tion.
Make sure that the jumper is reinserted prop-
erly and all pins are fully inserted.
J 2
J 1
Low Voltage Range conguration (by default):
Value range: Highlevel 4 - 16 Volts
RCA / Cinch 1 - 4 Volts
J 2
J 1
High Voltage Range conguration:
Value range: Highlevel 8 - 32 Volts
RCA / Cinch 2 - 8 Volts
Figure 1
Figure 2
Figure 3

HELIX ULTIMATE P SIX DSP Specifications

General

Brand	HELIX
Model	ULTIMATE P SIX DSP
Category	Amplifier
Language	English