HOW TO OPERATE:
1. Remove the unit from the box and take off any protective wrapping, and unwind the cord to its full
length.
2. Place the heater on a smooth level surface at least 50cm away from any obstacles.
3. Plug your fan heater into the power supply, making sure the master button is set to ‘Off’. Make sure
the power supply corresponds to the power indicated on the rating label and the heater is not
placed immediately below a socket outlet. Turn the master button ‘On’.
4. Press the on/off button – the heater will blow cool air initially until the heat setting is chosen. Press
one of the1000W button for low heating mode and press the other 1000W button for high heating
mode.
SWING BUTTON
This appliance also has a swing function. To switch the function on, press the swing button. To turn it
off, press the swing switch again.
HINTS/TIPS TO RETAIN THE HEAT IN YOUR HOME:
• Do not overheat your home, in winter the temperature of a heated room should be between 18-
21°C
• Choose the right size heater for the room that you wish to heat.
• Zone off the unoccupied rooms by closing doors, and curtains to limit heat loss.
• Use draft stoppers where possible, to keep the cold air from filtering in under doors.
• Avoid placing items, or sitting too close to the heater for optimal air flow.
CLEANING AND STORING:
• Always disconnect the appliance from the main power outlet before cleaning.
• Clean the outside of the heater by wiping with a damp, lint free cloth.
• Do not use any detergents/solvents or chemical agents to clean the heater.
• Make sure that the heater has cooled down completely before storing. Storing the heater in its
original box is highly recommended.
To Next Page
Loading...
Need help?
General
