“Operating Instructions” step 4.
Gas leakage from the Floater
Valve.
Some ingredients may stick to
the Floater’s Valve’s sealing
circle.
The Floater Valve’s sealing circle
may be broken.
Clean the Anti-Clog Filter.
The Floater Valve’s sealing circle
may need to be replaced.
Floater Valve does not rise up.
There may not be enough
ingredients/water to generate
enough pressure.
Gas leakage from lid or Pressure
Release Valve.
Ingredients or water need to be
at minimum level.
Unit may need to be set to the
manufacturer.
CONTACT CUSTOMER SERVICE IF ANY OF THESE ERRORS OCCUR
WARNING: PLEASE IMMEDIATELY CUT OFF CIRCUIT AND SENT UNIT TO OUR CUSTOMER SERVICE
DEPARTMENT IN CASE OF OTHER PROBLEMS.
NOTE: IF UNIT NEEDS TO BE REPLACED OR RETURNED TO THE MANUFACTURER, PLEASE CONTACT
CUSTOMER SERVICE.
SPECIFICATIONS
CUSTOMER SERVICE
Australian Customer Service
GAF Control (Sales) Pty Ltd
P.O Box 19
Altona North Victoria 3025
Phone: 1300 659 489
Hours: 9am-5pm (EST) Mon-Fri
www.gafcontrol.com.au
*This product may vary slightly to the product illustrated due to ongoing product development
To Next Page
Loading...
Need help?
General