PREPARATION FOR USE
UNPACKING AND SET UP
BATTERY BACK UP SYSTEM
Remove the clock radio from the carton and remove all packing material from
the clock radio. We suggest that you save the packing material, in the
unlikely event that your radio ever needs to be returned for service. The
original carton and packing material is the only safe way to pack your radio to
protect it from damage in transit.
Remove any descriptive labels or stickers on the front or top of the cabinet. Do
not remove any labels or stickers from the back or bottom of the cabinet.
Note the serial number on the bottom of your radio and write this number in the
space provided on Page 2 of this manual.
Place your clock radio on a level surface such as a table, desk or shelf, convenient
to an AC outlet, out of direct sunlight , and away from sources of excess heat,
dirt, dust, moisture, humidity, or vibration.
Unwind the A C power cord and extend it to its full length. The FM antenna is
built in to this cord. It must be fully extended to provide the best FM reception.
The battery back up system in this clock radio will maintain the time and alarm
settings in the event of a temporary power interruption. When the AC power is restored
the time and alarm settings will be correct. If the AC power is off at your wake up
time, the system will use the battery power to turn on the radio or buzzer alarm
as usual, as long as the back up battery is installed and has sufficient power
remaining.
The battery back up system requires one 9-volt battery, not included. We
recommend that you install an alkaline battery for longest life and best
performance.
.
4
To Next Page
Loading...
Need help?
General
