If required, you can route cables through the side outlet on the
mounting base (as shown in Figure 2-4).
4. Loosen the tilt lock screws, adjust the tilting position in a range
of 65 degrees, and tighten the tilt lock screws.
5. Rotate the black liner to adjust the panning position in a range of
180 degrees until you get the desired surveillance angle.
Surveillance Angle Adjustment Figure 2-4
As the lens has already been factory adjusted to the best imaging
effect, you just need to adjust the panning position and tilting
position to get the desired surveillance angle.
6. Reinstall the bubble and tighten the screws.
To Next Page
Loading...
Need help?
General
