EasyManuals Logo
Home>HIKVISION>Security Camera>DS-2CD2443G0-I

HIKVISION DS-2CD2443G0-I User Manual

HIKVISION DS-2CD2443G0-I
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Network Cube Camera·Quick Start Guide
21
3 Installation
Before you start:
Make sure the device in the package is in good condition and all
the assembly parts are included.
The standard power supply is 12V DC, please make sure your
power supply matches with your camera.
Make sure all the related equipment is power-off during the
installation.
Check the specification of the products for the installation
environment.
Make sure that the wall is strong enough to withstand four
times the weight of the camera and the bracket.
For the camera that supports IR, you are required to pay attention to
the following precautions to prevent IR reflection:
Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are attached seamlessly.
3.1 Memory Card Installation
This series of camera supports memory card installation. Follow the
steps below to install the memory card.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-2CD2443G0-I and is the answer not in the manual?

HIKVISION DS-2CD2443G0-I Specifications

General IconGeneral
Number of lenses1
Fixed focal length2.8 mm
Maximum aperture number1.6
Minimum aperture number1.2
Noise reductionYes
Total megapixels4 MP
Gain control typeAuto
Maximum resolution2688 x 1520 pixels
Image quality adjustmentBrightness, Contrast, Saturation, Sharpness
Video compression formatsH.264, H.264+, H.265, H.265+, M-JPEG
Noise reduction technology3D noise reduction
Supported graphics resolutions320 x 240, 352 x 240, 352 x 288, 640 x 360, 640 x 480 (VGA), 1280 x 720 (HD 720), 1920 x 1080 (HD 1080), 2304 x 1296, 2560 x 1440, 2688 x 1520
Sensor typeCMOS
Optical sensor size1/3 \
Pan range0 - 360 °
Tilt angle range0 - 90 °
Angle of rotation360 °
Camera shutter speed1/3 - 1/100000 s
Minimum illumination0 lx
TypeIP security camera
Placement supportedIndoor
Connectivity technologyWired
Built-in HDDNo
Compatible memory cardsMicroSD (TransFlash), MicroSDHC, MicroSDXC
Maximum memory card size128 GB
Alert notification typeE-mail
Intelligent Video Surveillance (IVS) system featuresFace detection
Number of users32 user(s)
User access levelAdministrator, Operator, User
Cabling technology10/100Base-T(X)
Networking standardsIEEE 802.1x, IEEE 802.3af
Ethernet interface typeFast Ethernet
Supported network protocolsTCP/IP, UDP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, RTCP, PPPoE, NTP, UPnP, SMTP, SNMP, IGMP, 802.1X, QoS, IPv6, UDP, Bonjour, SSL/TLS
Sample rate48 kHz
Voice codecsG.711alaw, G.711ulaw, G.722.1, G.726, MP2L2, PCM
Behavior analysisIntrusion detection, Line crossing detection
Operating temperature (T-T)-10 - 40 °C
Operating relative humidity (H-H)0 - 95 %
DC output current0.5 A
DC output voltage12
Power source typeDC, PoE
Power consumption (max)6 W
Power consumption (Power over Ethernet (PoE))7 W
LED typeIR
Infra-red wavelength850 nm
Night vision distance10 m
Form factorCube
Mounting typeDesk
Product colorBlack, White
Housing materialPlastic
Weight and Dimensions IconWeight and Dimensions
Depth32.6 mm
Width65.2 mm
Height102.8 mm
Weight128 g

Related product manuals