User Manual of Network Camera
74
Figure 6-44 Exception Settings
3. Click Save to save the settings.
6.6.6 Configuring Face Detection
Note: Face detection is only for certain modules, check the specification for whether
the module supports the function.
If you enable the face detection, once a face appears in the surveillance area, it will be
detected and certain actions may be triggered by the detection.
Figure 6-45 Face Detection Interface
Steps:
1. Enter the face detection settings interface:
Configuration > Advanced Configuration > Events > Face Detection
2. Check the Enable Face Detection to checkbox to enable the function.
3. (Optional)You can check the Enable Dynamic Analysis for Face Detection
checkbox if you want the face detected get marked with rectangle in the live
view.
Note: Select disable the rules from Configuration-Local Configuration-Live
View Parameters-Rules if you don’t want the detected face marked with the
green frame.
4. Configure the sensitivity [1~5] of the face detection.
5. (Optional)You can also configure the linkage action for face detection.
To Next Page
Loading...
Need help?
General
