HIKVISION DS-2CD2955FWD-I User Manual

Network Fisheye Camera·Quick Start Guide
17
2 Installation
Before you start:
● Make sure the device in the package is in good condition and all
the assembly parts are included.
● The standard power supply is 12V DC or PoE (802.3af), please
make sure your power supply matches with your camera.
● Make sure all the related equipment is power-off during the
installation.
● Check the specification of the products for the installation
environment.
● Make sure that the wall is strong enough to withstand four
times the weight of the camera and the bracket.
For the camera that supports IR, you are required to pay attention to
the following precautions to prevent IR reflection:
● Dust or grease on the dome cover will cause IR reflection.
Please do not remove the dome cover film until the installation
is finished. If there is dust or grease on the dome cover, clean
the dome cover with clean soft cloth and isopropyl alcohol.
● Make sure that there is no reflective surface too close to the
camera lens. The IR light from the camera may reflect back into
the lens causing reflection.
● The foam ring around the lens must be seated flush against the
inner surface of the bubble to isolate the lens from the IR LEDS.
Fasten the dome cover to camera body so that the foam ring
and the dome cover are attached seamlessly.

HIKVISION DS-2CD2955FWD-I Specifications

General

Type	IP security camera
Certification	CE, FCC
Placement supported	Indoor
Connectivity technology	Wired
Wide Dynamic Range (WDR)	Yes
Wi-Fi	No
Number of users	32 user(s)
Networking standards	IEEE 802.1x, IEEE 802.3af
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, RTCP, PPPoE, NTP, UPnP, SMTP, SNMP, IGMP, 802.1X, QoS, IPv6
Compatible memory cards	MicroSD (TransFlash), MicroSDHC, MicroSDXC
Maximum memory card size	128 GB
Form factor	Dome
Mounting type	Ceiling/wall
Product color	White
Ethernet LAN (RJ-45) ports	1
Camera shutter speed	1/3 - 1/100000 s
Minimum illumination	0 lx
Field of view (FOV) angle	180 °
Sensor type	CMOS
Optical sensor size	1/2.5 \
Fixed focal length	1.05 mm
Maximum aperture number	2.2
DC output current	0.5 A
DC output voltage	12
Power source type	DC, PoE
Power consumption (max)	5 W
Power consumption (Power over Ethernet (PoE))	7.5 W
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	0 - 95 %
LED type	IR
Infra-red wavelength	850 nm
Night vision distance	8 m
Total megapixels	5 MP
Maximum resolution	2560 x 1920 pixels
Supported video modes	240p, 576p, 960p
Image quality adjustment	Brightness, Contrast, Saturation, Sharpness
Video compression formats	H.264, H.264+, H.265, H.265+, M-JPEG
Noise reduction technology	3D noise reduction
Supported graphics resolutions	352 x 240, 704 x 576, 1280 x 960, 2048 x 1536 (QXGA), 2560 x 1920
Lens mount interface	M12
Harmonized System (HS) code	85258900

Weight and Dimensions

Height	41.2 mm
Weight	600 g
Diameter	119.9 mm