Figure 2-4 Secure Junction Box on Wall
7. Route the cables through the bottom cable hole or
side cable hole of the junction box and connect the
cables.
8. Fix the junction box cover on its body with three
PM3 × 16 L6 screws.
Figure 2-5 Fix Cover to Its Body
9. Refer to Step 6 of 2.1.1 Ceiling/Wall Mounting
without Junction Box to finish installation.
2.2 Installation of Type III Camera
2.2.1 Ceiling Mounting Without Junction Box
Steps:
1. Loosen the set screw.
2. Rotate the camera to align the triangle mark with
the screw hole, and dissemble the camera.
Figure 2-6 Dissemble Camera
3. Paste the drill template (supplied) to the place
where you want to install the camera.
4. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
5. Use three PA4 × 25 screws (supplied) to secure the
base to the ceiling.
To Next Page
Loading...
Need help?
General
