7. Route the cables through the bottom cable hole or
side cable hole of the junction box and connect the
cables.
8. Fix the junction box cover on its body with three PM3
× 16 L6 screws.
Figure 2-5 Fix the Cover to Its Body
9. Refer to Step 6 of 2.1.1 Ceiling/Wall Mounting to
finish installation.
2.1.3 Wall Mounting with Wall Mount
Before you start:
You need to purchase a wall mount in advance.
Steps:
1. Take apart the wall mount.
Figure 2-6 Take Apart Wall Mount
2. Paste the drill template (supplied) to the place where
you want to install the camera.
3. Drill the screw holes with a 5.5 mm drill and insert the
supplied wall plugs.
Figure 2-7 Drill Template for Wall Mount
4. Attach the main body of the wall mount to the wall
and secure it with three PA4 × 25 screws (supplied).
Figure 2-8 Secure Main Body to Wall
5. (Optional) Drill the cable hole, when the cables are
routed through the wall.
6. Secure the camera to the cover of the wall mount with
three PM4 × 13 screws and three M4 screws.
To Next Page
Loading...
Need help?
General
