HIKVISION DS-7208HQHI-K1 User Manual

Digital Video Recorder User Manual
174
Figure 12-17 Installed Certificate Property
Step 6 Check the checkbox to enable the HTTPS function.
Step 7 Click the Save button to save the settings.
12.2.8 Configuring Email
Purpose
The system can be configured to send an Email notification to all designated users if an event is
detected, e.g. an alarm or motion event is detected, etc.
Before configuring the Email settings, the DVR must be connected to a local area network (LAN)
that maintains an SMTP mail server. The network must also be connected to either an intranet or
the Internet depending on the location of the e-mail accounts to which you want to send
notification. Additional, the Preferred DNS server must be configured.
Before you start
Make sure you have configured the IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway and the
Preferred DNS Server in the Network Settings menu. Please refer to Chapter 12.1 Configuring
General Settings for detailed information.
Step 1 Go to Menu > Configuration > Network > Email.
Step 2 Select the Email tab to enter the Email Settings interface.
Figure 12-18 Email Settings Interface
Step 3 Configure the following Email settings:
Enable Server Authentication (optional): Check the checkbox to enable the server
authentication feature.

HIKVISION DS-7208HQHI-K1 Specifications

General

BNC input ports	1
Video input channels	8 channels
USB 2.0 ports quantity	2
Power consumption (typical)	7.5 W
Voltage	12 V
Product color	Black
Audio output channels	1.0 channels
Video compression formats	H.264, H.264+, H.265, H.265+
Analog signal format system	NTSC, PAL
Ethernet LAN	Yes
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, PPPoE, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, NFS, iSCSI, UPnP, HTTPS, ONVIF
HDD interface	Serial ATA
Maximum HDD capacity	6000 GB
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Weight	1780 g
Dimensions (WxDxH)	315 x 242 x 45 mm