HIKVISION DS-AT1000S/160 User Manual

DS-AT1000S Series Storage System Quick Start Guide
19
Chapter 4 Network
You are recommended to connect all the network interfaces to the Internet.
4.1 Activate Storage System
Purpose
For the first-time access, you need to activate the storage system by setting an admin password.
No operation is allowed before activation. You can only use Internet Explorer 8.0 and above to visit
storage system.
Step 1 Use an Ethernet cable to connect your computer and the management network interface of
storage system.
Step 2 Set your computer IP address. Ensure it is in the same network segment with the storage
system.
Default IP address of management network interface is 10.254.254.254.
Step 3 Visit https://10.254.254.254:2004 in web browser to access the storage system.
Step 4 Create password for storage system and confirm it.
STRONG PASSWORD RECOMMENDED– We highly recommend you create a strong password of
your own choosing (using a minimum of 8 characters, including upper case letters, lower case
letters, numbers, and special characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security system, resetting the
password monthly or weekly can better protect your product.
Step 5 Click Enter to activate the storage system.
4.2 Configure Network Parameters
4.2.1 Modify Network Parameters
Step 1 Go to Device > Information > Modify Network.

HIKVISION DS-AT1000S/160 Specifications

General

Brand	HIKVISION
Model	DS-AT1000S/160
Category	Storage
Language	English