HIKVISION DS-K1106 Series User Manual

DS-K1100 Series Card Reader
9
Color
Description
Purple
Beep Control (available for Wiegand Protocol)
Gray
Case Sensor (available for Wiegand Protocol)
Green
Wiegand W0 (available for Wiegand Protocol)
White
Wiegand W1 (available for Wiegand Protocol)
Black
GND
Orange
Red LED Control (available for Wiegand Protocol)
Red
PWR (DC +12V)
2.4 Wiring Cables
Purpose:
Wire the cables between controller and card reader, thus to
establish the communication between them.
Steps for RS-485 communication mode:
1. Set the DIP switch of No. 6 as 0.
2. Set the DIP switch of No. 1 ~ 5 for RS-485 address and
reading card mode. For details, please refer to 2.2
Introduction for DIP Switch.
3. Wire the cable between controller and card reader as
shown below.

HIKVISION DS-K1106 Series Specifications

General

Brand	HIKVISION
Model	DS-K1106 Series
Category	Card Reader
Language	English