To Next Page

To Previous Page

Chapter 3 Installaon

3.1 DIP Switch Descripon

The DIP switch module is shown below. The No. of DIP switch from le to right is 1 to 8.

When the switch is towards ON, it means the switch is enabled, otherwise, the switch is o. If you

set the DIP switch like the gure displayed below, its binary value is 00001100, and its decimal

value is 12.

Table 3-1 Descripon of DIP Switch

No. Descripon DIP Switch Status

1 to 4 Address of RS-485 1: 1

0: 0

5 Card Security

Note

●

For DS-K1108AE/AEK, the

DIP switch is reserved.

1: Enable M1 card encrypon

funcon, and disable door

open via NFC card.

0: Disable M1 card encrypon

funcon, enable door open via

NFC card, and read card No.

6 Wiegand protocol or RS-485

protocol.

1: Wiegand protocol

0: RS-485 protocol

7 Wiegand Protocol (available

when No. 6 is 1)

1: Wiegand protocol of 26-bit;

0: Wiegand protocol of 34-bit.

8 Matched Resistance (available

for RS-485 protocol)

1: Enable

0: Disable

DS-K1109 Series Card Reader User Manual

HIKVISION DS-K1109DKFB-QR User Manual

Questions and Answers: