HIKVISION DS-KH6320Y-WTE2 User Manual

3.3.1 Set Indoor Staon Network Parameters
Network connecon is mandatory for the use of the indoor staon. Set the network parameters
aer acvang the indoor staon. Only when the IP address of the indoor staon is in the same
network segment as other devices, it can work properly in the same system.
Steps
Note
The default IP address of the indoor staon is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1.
Tap Sengs → → Conguraon , and enter admin (acvaon) password.
2.
Tap
to enter the network sengs page.
Figure 3-17 Network Sengs
3.
Set the network parameters.
-
Enable DHCP, and the system can assign an IP address of the indoor staon automacally.
-
Disable the DHCP funcon, and set the IP address manually. You should set the device IP
address, the gateway, the DNS address.
Network Indoor Staon Conguraon Guide
16

HIKVISION DS-KH6320Y-WTE2 Specifications

General

Brand	HIKVISION
Model	DS-KH6320Y-WTE2
Category	Network Hardware
Language	English