DO NOT expose the device to high electromagnetic radiation or dusty environments.
For indoor-only device, place it in a dry and well-ventilated environment.
DO NOT aim the lens at the sun or any other bright light.
Make sure the running environment meets the requirement of the device. The operating temperature shall
be -30° to 65° C (-22° to 149° F), -H model: -40° to 65° C (-40° to 149° F), and the operating humidity shall
be 95% or less (non-condensing).
DO NOT place the device in extremely hot, cold, dusty, or damp locations, and do not expose it to high
electromagnetic radiation.
Emergency
If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the power cable,
and contact the service center.
Time Synchronization
Set up device time manually for the first time access if the local time is not synchronized with that of the
network. Visit the device via Web browse/client software and go to time settings interface.
Installation
Make sure the device is firmly secured to any wall or ceiling mountings.
Be sure that there is enough space to install the device and accessories.
Make sure that the device in the package is in good condition and all the assembly parts are included.
Make sure that the wall is strong enough to withstand at least diye times the weight of the device and the
mount.
The standard power supply is 12 VDC or PoE, please make sure your power supply matches your device.
Make sure that the power has been disconnected before you wire, install, or disassemble the device.
Make sure that no reflective surface is too close to the device lens. The IR light from the device may
reflect back into the lens causing reflection.
For device with this sticker, this device is intended for installation in a restricted
access location, access can only be gained by service persons or by users who have
been instructed about the reasons for the restrictions applied to the location and
about any precautions that shall be taken.
To Next Page
Loading...
Need help?
General
