HIKVISION iDS-9000HQHI-M8/S Series - Notify Surveillance Center; Configure Email Linkage; Trigger Alarm Output; Configure PTZ Linkage

6.4.3 Nofy Surveillance Center
The device can send an excepon or alarm signal to the remote alarm host when an event occurs.
The alarm host refers to the PC installed with client
soware (e.g., iVMS-4200, iVMS-5200).
Steps
1.
Go to System → Network → Advanced → More Sengs .
2.
Set the alarm host IP and alarm host port.
3.
Go to Linkage
Acon interface of the alarm detecon (e.g., moon detecon, video tampering,
face detecon, etc.).
4.
Select Nofy Surveillance Center.
6.4.4
Congure Email Linkage
The system can send an email with alarm informaon to a user or users when an alarm is detected.
Steps
1.
Go to System → Network → Advanced → Email .
2.
Set the email parameters.
3.
Click Apply.
4.
Go to the Linkage
Acon interface of the alarm detecon (e.g., moon detecon, video
tampering, face
detecon, etc.).
5.
Select Send Email alarm linkage acon.
6.4.5 Trigger Alarm Output
The alarm output can be triggered by the alarm input, moon detecon, video tampering
detecon, face detecon, line crossing detecon, and any all other events.
Steps
1.
Go to Linkage Acon of the alarm detecon (e.g., moon detecon, face detecon, line crossing
detecon, intrusion detecon, etc.).
2.
In Trigger Alarm Outputs, select the alarm output(s) to trigger.
3.
Go to System → Event → Normal Event → Alarm Output .
4.
Select an alarm output item from the list.
6.4.6
Congure PTZ Linkage
The system can trigger the PTZ acons (e.g., call preset/patrol/paern) when the alarm event, or
VCA detecon events occurs.
Before You Start
Make sure the connected PTZ or speed dome connected supports PTZ linkage.
Digital Video Recorder User Manual
93