To Next Page

To Previous Page

Installing the Stand

CAUTION

Be sure to disconnect the A/C power cord before installing a stand or Wall-Mount

brackets.

The LCD display is very fragile, and must be protected at all times when

installing the base stand. Be sure that no hard or sharp object, or anything that

could scratch or damage the LCD display, comes into contact with it. DO NOT

exert pressure on the front of the TV at any time because the screen could crack.

Follow the illustrations and instructions below to complete the installation steps:

1. Carefully place your TV face-down on a soft, flat surface to prevent damage to the

TV or scratching to the screen.

2. Remove the 2 stands from the accessory bag and then insert the stands into the

bottom slots of the TV.

3. Secure the BASE STAND to the TV with the 4 screws in accessory tightly.

Screws: ST4×12F (32")

ST4×25C (39")

Pictures are only for reference, actual product may vary in appearance.

NOTE

BASE STAND

WALL-MOUNT BRACKET SPECIFICATIONS

8.0~10.0mm

Wall-Mount hole pattern (mm) 200 × 200

Wall-Mount screw size M6

Hisense 32N4 User Manual

Questions and Answers: