2
Installing the Stand or Wall mount bracket
Installing the Stand
CAUTION
Be sure to disconnect the A/C power cord before installing a stand or Wall-Mount
brackets.
The screen is very fragile, and must be protected at all times when installing the base
stand. Be sure that no hard or sharp object, or anything that could scratch or damage
the screen, comes into contact with it. DO NOT exert pressure on the front of the TV
at any time because the screen could crack.
After the installation is complete, make sure the TV is steady on a table or firmly
attached to a wall mount, before removing all protective film, if any.
Follow the illustrations and textual instructions below to complete the installation steps:
1. Carefully place your TV face-down on a soft, flat surface to prevent damage to the
TV or scratching to the screen.
2. Remove the Base Stand from the accessory bag and then insert the stand into the
bottom slots of the TV.
3. Secure the Base Stand to the TV with the screws in accessory tightly.
Base Stand
Screws:
(ST4×14F) × 4(32")
(ST4×20F) × 4(40")
To Next Page
Loading...
Need help?
General
