2
Installing the Stand
Installing the Stand
CAUTION
Be sure to disconnect the A/C power cord before installing a stand or Wall-Mount
brackets.
The LED display is very fragile, and must be protected at all times when installing
the base stand. Be sure that no hard or sharp object, or anything that could scratch
or damage the LED display, comes into contact with it. DO NOT exert pressure on
the front of the TV at any time because the screen could crack.
Follow the illustrations and instructions below to complete the installation steps:
1. Carefully place your TV face-down on a soft, flat surface to prevent damage to the
TV or scratching to the screen.
The base stand of
70"
is pre-installed. If you need disassemble the base stand,
reverse operation.
NOTE
2. Secure the 2 Column bases to the
Base stand with the 4 screws in
accessary tightly.
Column base
Base stand
4 Screws: M4×8 (50"/55")
M4×12 (65")
M5×12 (70")
To Next Page
Loading...
Need help?
General
