14
Certification and compliance
NOTE:
The following warnings only apply to products with such certification.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
● Reorientorrelocatethereceivingantenna.
● Increasetheseparationbetweentheequipmentandreceiver.
● Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiver
is connected.
● Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of [20]
cm between the radiator and your body. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment complies with radio frequency exposure limits set forth by the Innovation,
Science and Economic Development Canada for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the
device and the user or bystanders.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.
Declaration of conformity
Trade Name: Hisense
Model: 55U8K / 55U88KM / 65U8K / 65U88KM / 75U8K / 75U88KM
Responsible Party: Hisense USA Corporation
Service Address: 105 Satellite BLVD Suite I, Suwanee, GA 30024
Service Phone Number: 1-888-935-8880
To Next Page
Loading...
Need help?
General
Weight and Dimensions
