6
6
.
.
C
C
O
O
N
N
T
T
R
R
O
O
L
L
M
M
O
O
D
D
E
E
has not received a signal from the remote controller when the set time is
up, it will automatically start and operate in the preset conditions.
6-3-3-2 Timer off: When set to stop in a set time by the remote controller,
the air conditioner will start in the timer off condition. When the set time
is up, the air conditioner will turn off after receiving a signal from the
remote controller. If the air conditioner has not received a signal from the
remote controller when the set time is up, it will turn off automatically.
6-3-3-3 Neither the turning on nor turning off operation will cancel the
timer function (Some remote controller has a simple one-hour timer off
function and excludes this operation).
6-3-4 Sleep
6-3-4-1 In the heating, cooling or dehumidifying mode, press the “Sleep”
button on the remote controller to start or cancel the sleep function in
turn, and at the same time the sleep icon on the display screen will be on
or off accordingly.
6-3-4-2 According to the different needs, there are four different sleep
modes to choose. During the time of sleep mode, the set temperature will
change automatically.
6-3-4-3 In default, the setting is to cancel the sleep function. Turning off
the unit will also cancel the sleep function.
6-3-4-4 The sleep function is valid for 8 hours. The air conditioner will
turns off and cancel the sleep function after the sleep function works for
8 hours.
6-3-5 High efficient run function (This function is invalid)
In the heating (except for the single cooling unit), cooling or
dehumidifying mode, it may be set for high efficient run with the indoor
fan speed changed to the high efficient fan speed and the compressor
operating at the highest frequency as available. If the display screen can
display the frequency, the frequency displayed on the screen is up to the
maximum. It will restore to the previous run state after 15 minutes
To Next Page
Loading...
Need help?
General
