Installing the battery
You must install and charge the battery to use your
phone. Insert the ridge at the top of the battery into
the base of the phone, make sure to touch the metal
contact on the phone, then push the battery down
and snap it into place.
Note:
Your phone is designed to be used only with original
batteries and chargers. Use of other batteries or
chargers may cause damage to your phone and the
warranty will be void.
Removing the battery
Make sure your phone is powered off to avoid the
important information getting lost.
Hold battery bottom and remove the battery from the
phone.
Charging the battery
New batteries are shipped partially charged. Before
you can use your phone, you need to charge the
battery. Some batteries will have best performance
after several full charge/discharge cycles.
1. Connect data cable and charger, plug one end
into your phone’s data port.
2. Plug the other end of the charger into the
appropriate electrical outlet (100~240V AC).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
