--- 21 ---
1. Remove the four Bolts M8 x 35 [46], Spring Washers M8 [47] and Bolt Washers M8 [48], then remove Fence
(A) [65] and Fence (B) [54].
2. Loosen the Clamp Lever [5] and remove the Machine Screw (W/Washers) M6 x 20 (Black) [4]. Turn the Bolt
(Left Hand) M10 [6] and remove it from the Hinge [16].
3. Remove Shaft (D) [13] and remove the Hinge [16] from the Turn Table [36].
4. Remove Table Insert (A) [33] and Table Insert (B) [32] from the Turn Table [36] by removing each fixing screw.
Remove the Side Handle [37] to remove the Spring Plate [59] from the Turn Table [36].
5. Remove the Nylon Nut M8 [28] and remove the Turn Table [36] from the Base Ass'y [67].
To Next Page
Loading...
Need help?
General
