English
14
CUTTING PROCEDURES
1. Set the machine body (base) on the
material to be cut; use the side on the base
to align the diamond wheel with the cutting
line. (Fig. 5)
2. Turn the switch ON with the diamond wheel
initially kept off the material to be cut.
The power switch is turned ON when the
trigger is pulled by one’s finger, and is
turned OFF when the trigger is released. If
the stopper is depressed after the trigger is
pulled, the power switch becomes locked,
even though the trigger is released, proving
particularly convenient for continuous
operation. When the power switch is to be
turned OFF, the stopper can be released by
pulling the trigger, and the power switch is
turned OFF upon releasing the trigger.
CAUTION:
● Do NOT use the diamond wheel for cutting along curves or at angles; otherwise, it
may be damaged, resulting in extremely shortened service life.
● Before starting to cut, confirm that the diamond wheel has attained full-speed
revolution.
● Should the diamond wheel stop or make an abnormal noise while operating, promptly
turn OFF the switch.
● Always take care in preventing the power cord from coming near to the revolving
diamond wheel.
● When finished with a job, pull out the plug from the power receptacle.
Guide line
on the base
Guide line
on the
base
Base
Cutting line
Fig. 5
To Next Page
Loading...
Need help?
General
