Hitachi CS35EK User Manual

Slightly move the bar back and forth and make
sure the chain tension boss (4) fits into the hole
(5) in the bar properly.
2. Confirm the direction of saw chain (1) is
correct as in the figure, and align the chain on
the sprocket. (Fig. 1-2)
3. Guide the chain drive links into the bar
groove all around the bar.
4. Install the side case (1) onto the guide bar
clamp bolts while inserting location pin (2) on
the side case into the location hole (3) on the
unit. (Fig. 1-3)
Then finger tight the clamp nuts. (Fig. 1-3B)
3. Assembly procedures
NOTE!
Fig.1-0 Fig.1-2Fig.1-1
Fig.1-3 Fig.1-3B
Fig.1-4 Fig.1-5
WARNING!
5. Raise the bar end, and tighten the chain (1)
by turning the tension adjustment bolt (2)
clockwise. To check proper tension, lightly
lift up the center of chain and there should
be about 0.5-1.0mm clearance between bar
and edge of drive link (3).
CAUTION!
PROPER TENSION IS EXTREMELY IM-
PORTANT! (Fig.1-4, 5)
6. Raise the bar end and securely tighten the
chain bar clamp nuts with the box wrench.
(Fig. 1-4)
7. A new chain will stretch so adjust the chain
after a few cuts and watch chain tension
carefully for the first half hour of cutting.
NOTE!
Check the chain tension frequently for
optimum performance and durability.
CAUTION!
When the chain is excessively tightened, the
bar and chain will be damaged rapidly.
Conversely, when the chain is excessively
loosened, it may get out of the groove in the
bar.
Always wear gloves when touching the chain.
During operation, hold chain saw firmly
with both hands. A single hand operation
may cause serious injury.
WARNING!
Never try to start engine without side case
securely fastened.
* Install the spiked bumper (1) (If so equipped)
to the unit with the two screws. (Fig.1-0)
1. Remove the side case by unscrewing two
guide bar clamp nuts, and install the guide
bar (1) onto the bolts (2), then push it toward
the sprocket (3) as far as it will go.
Make sure that the boss of chain tension
adjust bolt (4) fits into the hole of the bar (5).
(Fig. 1-1)
GB-6

Hitachi CS35EK Specifications

General

Brand	Hitachi
Model	CS35EK
Category	Chainsaw
Language	English