English
19
Work Clutch dial position Suggestions
Wood
Drilling Steel Use for drilling purpose.
Aluminum
Machine
1 – 22
Use the bit and socket matching the
Screw
screw screw diameter.
tightening
Wood
1 –
Use after drilling a pilot hole.
screw
Clutch dial
Tightening torque Operation example
position
Approximately 9 in.-lbs. (10 kg-cm)
Approximately 15 in.-lbs. (17 kg-cm)
Approximately 23 in.-lbs. (26 kg-cm)
Approximately 35 in.-lbs. (40 kg-cm)
Approximately 43 in.-lbs. (49 kg-cm)
Approximately 52 in.-lbs. (60 kg-cm)
High speed: approximately 71 in.-lbs.
(82 kg-cm) (DS14DFL)
approximately 97 in.-lbs.
(112 kg-cm) (DS18DFL)
Low speed: approximately 274 in.-lbs.
(347 kg-cm) (DS14DFL)
approximately 374 in.-lbs.
(459 kg-cm) (DS18DFL)
Machine screw
tightening Screw
tightening for soft wood
material
Screw tightening for
hard wood material
Thick screw tightening
When used as a drill.
1
3
7
13
17
22
NOTE:
The selected content shown in Table 5 indicates
the differences according to screw type, screw size
and material used.
CAUTION:
●
While operating the Cordless driver drill, take care
not to lock the motor.
If the motor is locked, immediately turn the power
off.
If the motor is locked for a while, the motor or
battery will be burnt.
●
Do not tighten too strongly as the screw heads
will be damaged.
THE SCOPE AND SUGGESTIONS FOR USES
Table 6
HOW TO SELECT TIGHTENING TORQUE
Table 7
●
To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the causes
of overloading.
01Eng_DS14DFL_US 7/30/09, 14:2519
To Next Page
Loading...
Need help?
General
